![]() Try older build like r41517 or r41791 for your C7. ![]() If other C7 owners are able to recreate same issue, a ticket should be placed on bug tracking. You should post issues on the r44700 build thread. Posted: Sun 15:25 Post subject: Re: TP-Link Archer C7 v2 (AC1750) - DD-WRT Version 44700 Ha Pogo - A minimal level of ability is expected and needed.Īt some point, people just get plain tired of this place. "Life is but a fleeting moment, a vapor that vanishes quickly All is vanity" Also, you're probably accessing the router with the rest of your internet traffic, which will cause issues. Last edited by mqshaw on Sun 17:53 edited 1 time in totalįirefox ESR, Safari, Internet Explorer. I fear that the Version 44700 FW has a bug, but do not know who or how to report this, so hoping that this post helps the community. I tried using the TFPT method to break into the boot loader sequence, but the TTL=100 would never come up.ģ) I tried SSH, but could not get that to work either.Ĥ) Finally, I put the factory FW on a FAT32 USB thumb drive, attached it to the USB port on the router, rebooted the router with the thumb drive connected, voila! the TP-Link stock FW was re-installed and I was able to get my router backup and running. I tried a number of different methodsġ) Using the WebUI installer, every time I hit the install button, the page would refresh and I would get the same error.Ģ) Using the instructions posted at. I then spent the next few hours trying to roll back the FW. I tried nvram erase, nothing seemed to fix the issue. I tried pinging the router using (ping -t 192.168.1.1) and the router was happily responding to the pings even after the Embedded Web Server locks up. The only thing I could do was reboot the router. But, after a few minutes using the Web UI it would lock, and respond "cannot access destination IP address". Once installed, the router came up as expected, just like my 2 other routers with DD-WRT installed on them. ![]() It took a while for me to figure out where to get a version that I could install, but I was able to find the US version, and install the DD-WRT FW. Last night I installed the following build on my TP-Link Archer C7 v2 (AC1750) router using the following FW build. Posted: Sun 0:26 Post subject: TP-Link Archer C7 v2 (AC1750) - DD-WRT
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |